P0713

DTC P0713 FLUID (OIL) TEMPERATURE SENSOR CIRCUIT - HIGH





COMPONENT LOCATION

GENERAL DESCRIPTION
Refer to DTC P0711. P0711

DTC DESCRIPTION
Refer to DTC P0711. P0711

DTC DETECTING CONDITION





[2.0L]





[2.7L]

SPECIFICATION
Refer to DTC P0711. P0711

MONITOR SCANTOOL DATA
Refer to DTC P0711. P0711

TERMINAL & CONNECTOR INSPECTION
1. Many malfunctions in the electrical system are caused by poor harness and terminals. Faults can also be caused by interference from other electrical systems, and mechanical or chemical damage.
2. Thoroughly check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration, or damage.
3. Has a problem been found?
YES >>
^ Repair as necessary and go to "Verification vehicle Repair" procedure.
NO >>
^ Go to "Signal circuit inspection" procedure.

SIGNAL CIRCUIT INSPECTION
1. Ignition "OFF".
2. Disconnect the "TRANSAXLE FLUID TEMPERATURE SENSOR" connector.





3. Measure the voltage between terminal "1" of the "TRANSMISSION FLUID TEMPERATURE SENSOR" harness connector and chassis ground.
Specification: Approximately 5V
4. Is voltage within specifications?
YES >>
^ Go to "Ground circuit inspection" procedure.
NO >>
^ Check for short to ground in harness. Repair as necessary and Go to "Verification Vehicle Repair" procedure.

GROUND CIRCUIT INSPECTION
1. Ignition "OFF".
2. Disconnect the "TRANSAXLE FLUID TEMPERATURE SENSOR" connector.





3. Measure the resistance between terminal "2" of the "TRANSMISSION FLUID TEMPERATURE SENSOR" harness connector and chassis ground.
Specification: Approximately 0 Ohms
4. Is resistance within specifications?
YES >>
^ Go to "Component inspection" procedure.
NO >>
^ Check for open in harness. Repair as necessary and Go to "Verification Vehicle Repair" procedure.

COMPONENT INSPECTION
1. CHECK "TRANSAXLE FLUID TEMPERATURE SENSOR"
1. Ignition "OFF".
2. Disconnect the "TRANSAXLE FLUID TEMPERATURE SENSOR" connector.





3. Measure the resistance between terminals "1" and "2" of the TRANSMISSION FLUID TEMPERATURE SENSOR".
Specification: Refer to "Reference data"





[REFERENCE DATA]

4. Is resistance within specifications?
YES >>
^ Go to "CHECK PCM/TCM" as below.
NO >>
^ Replace OIL TEMPERATURE SENSOR as necessary and Go to "Verification Vehicle Repair" procedure.
2. CHECK TCM
1. Ignition "ON" & Engine "OFF".
2. Connect "TRANSAXLE FLUID TEMPERATURE SENSOR" connector.
3. Install scantool and select a SIMU-SCAN.





4. Simulate voltage (0-5V) to OIL TEMPERATURE SENSOR signal circuit.
5. Is FLUID TEMP. SENSOR signal value changed according to simulation voltage?
YES >>
^ Thoroughly check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration, or damage. Repair or replace as necessary and then go to "Verification of Vehicle Repair" procedure.
NO >>
^ Substitute with a known-good PCM/TCM and check for proper operation. If the problem is corrected, replace PCM/TCM as necessary and then go to "Verification of Vehicle Repair" procedure.

VERIFICATION OF VEHICLE REPAIR
Refer to DTC P0560. P0560