Sunroof / Moonroof: Adjustments

INITIAL SETTING (GENERAL, OPERATION)




To the initial state, with the ignition key OFF and sunroof CLOSED, simultaneously press the open and up switches and turn the ignition switch ON, then the sunroof will automatically tilt up and down and stops.

NOTE:
- Always initiates the sunroof in the following condition.
- After manual operation
- After parts replacement including motor, controller, harness
- Malfunction of sunroof wiring
- Abnormal operation after battery and fuse replacement
- Follow the general operation produce for initial setting after reassembling.

OPERATING THE SUNROOF EMERGENCY HANDLE




1. Use the sunroof emergency handle to close and open the sunroof manually for the following case only:
- To close the sunroof before driving a vehicle in a rainy day or on the highway if the sunroof cannot be closed due to failure of the sunroof motor or controller.

2. Operating method
- Remove the overhead console. Push the emergency handle up into the hexagonal drive (A) of the sunroof motor (B). You must push hard enough to disengage the motor clutch; otherwise the emergency handle will slip due to uncompletely fit in the motor.
- Carefully turn the emergency handle clockwise to close the sunroof.
- After closing the sunroof, wiggle the handle back and forth as you remove the tool from the motor, to ensure the motor clutch reengages.
- A 5 mm hex socket may be used in place of the emergency handle, with a "Speeder" type handle.

CAUTION: Do not use power tools to operate the sunroof. Damage to the components may occur.