Removal and Installation

POWER STEERING HOSES





COMPONENTS

REMOVAL AND INSTALLATION





While installing the tube and hose assembly, be sure to align white marks on each fitting.

PRESSURE HOSE AND TUBE
1. After draining the power steering fluid, remove the pressure hose mounting clamp.





2. Lift up the vehicle and remove the mounting clamp which is holding both the pressure tube and the return tube.
3. Detach the pressure tube fitting in the gear box.





4. Lower the vehicle and remove the connector.





5. Remove the pressure hose and tube assembly.
6. Installation is the reverse of removal.

NOTE:
1. Install the pressure hose and tube so that they are not twisted and they do not come in contact with any other parts.
2. After installation, bleed the system.

RETURN TUBE AND HOSE





1. Detach the hose from the power steering fluid reservoir.
2. Remove the return tube and hose mounting clamps.





3. Raise the vehicle and remove the mounting clamp which is holding both the pressure tube and the return tube.
4. Remove the pressure tube and the return tube fitting in the gear box.
5. Lower the vehicle and disconnect the clamp holding the return tube and hoses.





6. Remove the return tube and hoses.
7. Installation is the reverse of removal.

NOTE:
1. Install the return tube and hoses so that they are not twisted and they do not come in contact with any other parts.
2. After installation, air bleed the system.