P0708

DTC P0708 TRANSAXLE RANGE SWITCH - MULTI-INPUT

COMPONENT LOCATION
Refer to DTC P0707. P0707

GENERAL DESCRIPTION
Refer to DTC P0707. P0707

DTC DESCRIPTION
Refer to DTC P0707. P0707

DTC DETECTING CONDITION:

SCHEMATIC DIAGRAM
Refer to DTC P0707. P0707

MONITOR SCANTOOL DATA
Refer to DTC P0707. P0707

TERMINAL & CONNECTOR INSPECTION
Refer to DTC P0707. P0707

POWER SUPPLY CIRCUIT INSPECTION
1. Disconnect "TRANSAXLE RANGE SWITCH" connector.
2. Ignition "ON" & Engine "OFF".
3. Measure voltage between each terminal of the sensor harness connector and chassis ground.





4. Is voltage within specifications?
YES
^ Go to "Signal circuit inspection" procedure.

NO
^ Check for short in harness. Repair as necessary and go to "Verification of vehicle repair" procedure.

SIGNAL CIRCUIT INSPECTION
1. Ignition "OFF".
2. Disconnect "TRANSAXLE RANGE SWITCH" and "PCM" connector.
3. Measure resistance between each terminals of the sensor harness to check for Short.





4. Is resistance within specifications?
YES
^ Go to "Component inspection" procedure.

NO
^ Check for open in harness. Repair as necessary and go to "Verification of vehicle repair" procedure.

COMPONENT INSPECTION
Refer to DTC P0707. P0707

VERIFICATION OF VEHICLE REPAIR
Refer to DTC P0707. P0707