Power Door Lock Actuator: Testing and Inspection
POWER DOOR LOCK ACTUATORSINSPECTION
FRONT DOOR LOCK ACTUATOR
1. Remove the front door trim panel.
2. Disconnect the 6P connector from the actuator.
3. Check actuator operation by connecting power and ground according to the table. To prevent damage to the actuator, apply battery voltage only momentarily.
REAR DOOR LOCK ACTUATOR
1. Remove the rear door trim panel.
2. Disconnect the 6P connector from the actuator.
3. Check actuator operation by connecting power and ground according to the table. To prevent damage to the actuator, apply battery voltage only momentarily.
TAILGATE LOCK ACTUATOR (3 DOORS)
1. Remove the tailgate trim panel.
2. Disconnect the 6P connector from the actuator.
3. Check actuator operation by connecting power and ground according to the table. To prevent damage to the actuator, apply battery voltage only momentarily.
FRONT DOOR LOCK SWITCH
1. Remove the front door trim panel.
2. Disconnect the 6P connector from the actuator.
3. Check for continuity between the terminals in each switch position according to the table.
REAR DOOR LOCK SWITCH
1. Remove the rear door trim panel.
2. Disconnect the 6P connector from the actuator.
3. Check for continuity between the terminals in each switch position according to the table.
TRUNK LID SWITCH (4 DOORS)
1. Disconnect the negative battery terminal.
2. Remove the rear trunk lid trim, and then remove the trunk lid switch from the trunk lid striker.
3. Disconnect the 1P connector from the rear harness.
4. Check for continuity between the terminal and body while pushing the rod.
TAILGATE LOCK SWITCH (3 DOORS)
1. Remove the tailgate trim panel.
2. Disconnect the 6P connector from the actuator.
3. Check for continuity between the terminals in each switch position according to the table.
