Power Flow

POWER FLOW





For each shift condition, certain holding units in the transaxle are used. Knowing which holding element is used and how they are connected in the transaxle, we can trace the power flow through the transaxle for each shift condition. One set of pinions, the short pinions, meshes with the reverse sun gear.

The other set, the long pinions, meshes with both the forward sun gear and with the annulus gear. The two sets of pinions also mesh with each other in pairs. The pinion carrier is built as a unit with the low reverse brake hub and the outer race of the one-way clutch. Power input is to either of the two sun gears.

The reverse sun gear is connected to the front clutch retainer through the kick-down drum. The forward sun gear is connected to the rear clutch hub. So by engaging either the front or the rear clutch, power is directed to either the reverse or the forward sun gear. When both front and rear clutches are engaged, the gear set is locked, and power passes directly through the transaxle. Power output is through the annulus gear, which has the parking sprag on the outer circumference and is connected to the output flange.

1ST GEAR ("D" AND "2" RANGE):

1ST GEAR ("L" RANGE):

2ND GEAR ("D" AND "2" RANGE):

3RD GEAR ("D" RANGE):

4TH GEAR ("D" RANGE):

"R" RANGE: