Oil Pump

OIL PUMP

REMOVAL
1. Drain engine oil.
2. Using SST(09215-3C000) remove lower oil pan(A).





NOTE: Be careful not to damage the contact surfaces of upper oil pan and lower oil pan.

CAUTION:
^ Insert the SST between the oil pan and the ladder frame by tapping it with a plastic hammer in the direction of (1) arrow.
^ After tapping the SST with a plastic hammer along the direction of (2) arrow around more than 2/3 edge of the oil pan, remove it from the ladder frame.
^ Do not turn over the SST abruptly without tapping.
It can result in damage of the SST

3. Remove oil pump chain cover(A).





4. Remove oil pump chain sprocket(A).





5. Remove oil pump(A).





INSTALLATION
1. Install oil pump(A).

Tightening torque 20.6-22.6 Nm (2.1-2.3 kgf-m, 15.2-16.6 lb-ft)

NOTE: Always use a new O-ring(B).





2. Install oil pump sprocket(A) and oil pump chain on the oil pump.





3. Install oil pump chain cover(A).





4. Install lower oil pan.
a. Using a gasket scraper, remove all the old packing material from the gasket surfaces.
b. Before assembling the oil pan, the liquid sealant TB1217H should be applied on upper oil pan.
The part must be assembled within 5 minutes after the sealant was applied.





CAUTION:
^ Clean the sealing face before assembling two parts.
^ Remove harmful foreign materials on the sealing face before applying sealant.
^ When applying sealant gasket, sealant must not be protrude into the inside of oil pan.
^ To prevent leakage of oil, apply sealant gasket to the inner threads of the bolt holes.

e. Install lower oil pan.
Uniformly tighten the bolts in several passes.





f. After assembly, wait at least 30 minutes before filling the engine with oil.