P1693
DTC P1693 IMMOBILIZER-TRANSPONDER ERRORComponent Location:
GENERAL DESCRIPTION
The ECM and the SMARTRA communicate by dedicated line. During this communication of ECM and SMARTRA the K line of ECM cannot be used for communication. The ECM controls the communication either to SMARTRA or to other devices (e.g. scanner) on K line by switching of a multiplexer and specific communication procedures. The multiplexer is a part of ECM H/W.
DTC DESCRIPTION
The ECM sets DTC P1693 if there's abnormal response from transponder.
DTC Detecting Condition:
Diagnostic Circuit System:
MONITOR SCANTOOL DATA
1. Check transponder and ECU status
1. IGN "ON" & Engine "OFF"
2. Monitor the "ECU, KEY and Smartra STATUS" Parameter on the Scantool.
Specification : "LEARNT"
3. Have both the ECM and KEY status been learnt ?
YES - Check connectors for looseness, poor connection, bending, corrosion, contamination deterioration, damage on the ECM or SMARTRA.
And this DTC has not been erased in previous repair. Repair or replace as necessary and then go to "Verification of Vehicle Repair" procedure.
NO - Go to "Component Inspection" Procedure.
COMPONENT INSPECTION
1. Check transponder
1. IGN "ON" & Engine "OFF"
2. Neutralize ECM and Register transponder key by scantool.
NOTE: Pin code is required to Neutralize ECM and to Register transponder key
3. Are Neutralizing and Registering completed normally ?
YES - Check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration, or damage. Repair or replace as necessary and then go to "Verification of Vehicle Repair" procedure.
NO - Substitute with a known-good transponder and perform the key teaching procedure.
If the problem is corrected, replace transponder and then go to "Verification of Vehicle Repair" procedure.
VERIFICATION OF VEHICLE REPAIR
After a repair, it is essential to verify that the fault has been corrected.
1. Connect scantool and select "Diagnostic Trouble Codes (DTCs)" mode and then clear DTC.
2. Operate the vehicle and monitor the DTC on the scantool.
3. Are any DTCs present?
YES - Go to the applicable troubleshooting procedure.
NO - System is performing to specification at this time.