Power Door Lock Relay: Testing and Inspection
POWER DOOR LOCK RELAYINSPECTION
DOOR LOCK
1. Disconnect the negative (-) battery terminal.
2. Remove the ICM relay box.
3. Check for continuity between the terminals.
4. There should be continuity between the No. 5 terminal and No. 14 terminals in the ICM-B when power and ground are connected to the No. 11 terminal and No. 13 terminal in the ICM-B.
5. There should be no continuity between the No. 5 terminal and No. 14 terminal in the I/P-D when power is disconnected.
DOOR UNLOCK
1. Disconnect the negative (-) battery terminal.
2. Remove the ICM relay box.
3. Check for continuity between the terminals.
4. There should be continuity between the No.4 terminal and No.14 terminal in the ICM-B when power and ground are connected to the No.10 terminal and No.13 terminal in the ICM-B.
5. There should be no continuity between the No.4 terminal and No.14 terminal in the ICM-B when power is disconnected.
TRUNK LID OPEN
1. Disconnect the negative (-) battery terminal.
2. Remove the passenger compartment junction box.
3. Check for continuity between the terminals.
4. There should be continuity between the No. 3 terminal in the I/P-H and the No. 2 terminal in the I/P-D when power and ground are connected to the No. 3 terminal in the I/P-H and the No. 28 terminal in the I/P-F.
5. There should be no continuity between the No. 3 terminal in the I/P-H and the No. 2 terminal in the I/P-D when power and ground are connected to the No. 3 terminal in the I/P-H and the No. 28 terminal in the I/P-F.
