Seat Assembly Replacement

SEAT ASSEMBLY REPLACEMENT

1. Remove the seat assembly mounting cover.
2. After loosening the seat assembly mounting bolts and nuts, remove the seat assembly (A).






3. Disconnect the connectors, and remove the seat assembly.

[DRIVER'S]
- Disconnect the airbag connector (A), seat belt buckle connector (B), STPS connector (C), and the remove the seat assembly.






[PASSENGER'S]
- Disconnect the airbag connector (A), seat belt buckle connector (B), WCS connector (C), and then remove the seat assembly.






4. Installation is the reverse of removal.

CAUTION: SEAT MOUNTING BOLT INSTALLATION PROCEDURE (manual seat only)
- Set the seat into the most rearward position. Check the each slide is locked, and then tighten the front mounting bolt temporarily.
- Set the seat into the most forward position. Check the each slide is locked, and then tighten the rear mounting bolt completely.
- Set the seat into the most rearward position. Check the front mounting bolt completely.
- Check that the seat operates to and fro smoothy and the locking portion locks properly.