Programming and Relearning

ASP (ABSOLUTE STEERING POSITION) CALIBRATION or EPS TYPE RECOGNITION

CAUTION WHEN ASP (ABSOLUTE STEERING POSITION) CALIBRATION OR EPS TYPE RECOGNITION
^ Check if the battery is fully charged before ASP calibration or EPS type recognition.
^ Be careful not to disconnect any cables connected to the vehicle or scan tool during ASP calibration or EPS type recognition.
^ When the ASP calibration or EPS type recognition is completed, turn the ignition switch off and wait for several seconds, then start the engine to confirm normal operation if the vehicle.

SCAN TOOL (HI-SCAN PRO) INSTALLATION
1. Attach the CAN interface module to the Hi-Scan Pro main body and securely tighten the two bolts.
2. Install the CAN interface module to the Data Link Cable and securely tighten the two bolts.

ASP CALIBRATION PROCEDURE
1. Plug DLC cable from a scan tool into the vehicle's data link connector located under the instrument panel on the driver's side.
2. Turn the ignition switch ON position.
3. Turn the steering wheel so that the front wheel can face straight ahead.
4. Select a model and ELECTRIC POWER STEERING.





5. Select the ASP CALIBRATION and press ENTER.





6. Check the massage on the screen and press ENTER.





7. Confirm the vehicle condition (IG On) and then turn the steering wheel until massage changes to the next screen.





8. When the massage is displayed on the screen as follows, turn the steering wheel so that the front wheel can face straight ahead and then press ENTER,





9. When the calibration is completed, the massage will be displayed on the screen as follows.





EPS TYPE RECOGNITION PROCEDURE
1. Plug DLC cable from a scan tool into the vehicle's data link connector located under the instrument panel on the driver's side.
2. Turn the ignition switch ON position.
3. Select a model and ELECTRIC POWER STEERING.





4. Select the EPS type recognition and press ENTER.





5. Select the affected area and press ENTER.





6. When the EPS type recognition is completed, the massage will be displayed on the screen as follows.