Installation

REAR LOWER ARM

INSTALLATION
1. Connect the rear lower arm (A) with the cross member and then temporarily tighten the bolt (B).





2. Install the coil spring (A) and support the lower portion of the rear lower arm with a jack.
3. Adjust height of the jack to place the bolt (B) holding rear lower arm and carrier assembly through the mating holes.
4. Tighten the bolt and nut (B, C) to the specified torque.





5. Install the rear wheel & tire.

Tightening torque Nm (kgf-m, lb-ft): 90-110 (9.0-11.0, 65-80)

CAUTION: Be careful not to damage to the hub bolts when installing the rear wheel & tire.