P0708
DTC P0708 TRANSAXLE RANGE SWITCH - HIGH INPUTCOMPONENT LOCATION
Refer to DTC P0707. P0707
GENERAL DESCRIPTION
Refer to DTC P0707. P0707
DTC DESCRIPTION
The TCM sets this code when the Transaxle Range Switch outputs multiple signals for more than 30 seconds.
DTC DETECTING CONDITION
DTC DETECTING CONDITION:
SPECIFICATION
Refer to DTC P0707. P0707
SCHEMATIC DIAGRAM
Refer to DTC P0707. P0707
MONITOR SCAN TOOL DATA
1. Connect SCAN TOOL to data link connector (DLC).
2. Ignition ON & Engine OFF.
3. Monitor the 'TRANSAXLE RANGE SWITCH parameter on the SCAN TOOL.
4. Move selector lever from P range to L range.
5. Does TRANSAXLE RANGE SWITCH follow the reference data?
YES > Fault is intermittent caused by poor contact in the sensor's and/or TCM (PCM)'s connector or was repaired and TCM (PCM) memory was not cleared. Thoroughly check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration or damage. Repair or replace as necessary and go to Verification of Vehicle Repair procedure.
NO > Go to TERMINAL & CONNECTOR INSPECTION procedure.
TERMINAL & CONNECTOR INSPECTION
Refer to DTC P0707. P0707
POWER SUPPLY CIRCUIT INSPECTION
1. Disconnect TRANSAXLE RANGE SWITCH connector.
2. Ignition ON & Engine OFF.
3. Measure voltage between each terminal 8 of the sensor harness connector and chassis ground.
Specification: Approximately B+
Specification:
4. Is voltage within specifications?
YES > Go to Signal circuit inspection procedure.
NO > Check for Short in harness. Repair as necessary and Go to Verification of Vehicle Repair procedure.
SIGNAL CIRCUIT INSPECTION
1. Ignition OFF.
2. Disconnect TRANSAXLE RANGE SWITCH and TCM (PCM) connector.
3. Measure resistance between each terminals of the sensor harness to check for Short.
Specification: Infinite
Specification:
4. Is resistance within specifications?
YES > Go to Component inspection procedure.
NO > Check for Open in harness. Repair as necessary and Go to Verification of Vehicle Repair procedure.
COMPONENT INSPECTION
Refer to DTC P0707. P0707
VERIFICATION OF VEHICLE REPAIR
Refer to DTC P0707. P0707