Air Bag Control Module: Service and Repair
SRS CONTROL MODULEREMOVAL
1. Disconnect the negative (-) cable from battery and wait for at least 3 minutes.
2. Remove ignition key from the vehicle.
3. Remove the center console.
4. Pull back the lever, then disconnect the SRSCM harness connector (A). Loosen the bolt (B), then remove the SRSCM (C).
SRSCM mounting bolt : 0.97 - 1.39 kgf.m (9.5 - 13.6 N.m, 7.0 - 10.03 lb.ft)
5. Installation is the reverse of removal.
NOTE:
- Turn the ignition switch ON; the SRS indicator light should turn on for about six seconds and then go off
- Always use new bolts when installing the SRSCM.