Side Impact Sensor (SIS)

SIDE IMPACT SENSOR (SIS)

REMOVAL

CAUTION:
- Removal of the airbag must be performed according to the precautions/procedures described previously.
- Before disconnecting the side impact sensor connector(s), disconnect the side airbag connector(s).
- Do not turn the ignition switch ON and do not connect the battery cable while replacing the side impact sensor.

1. Disconnect the negative battery cable, and wait at least three minutes before beginning work.
2. Remove the front door scuff trim.
3. Remove the center pillar trim.




4. Remove the bolt (A) then remove the side impact sensor (B).

INSTALLATION

CAUTION:
- Be sure to install the harness wires so that they are not pinched or interfere with other parts.
- Do not turn the ignition switch ON and do not connect the battery cable while replacing the side impact sensor.

1. Install the new side impact sensor with the bolt then connect the SRS harness connector to the side impact sensor.
2. Reinstall the belt pretensioner.
3. Reconnect the negative battery cable.
4. After installing the side impact sensor, confirm proper system operation: Turn the ignition switch ON: The SRS indicator light should turn on about six seconds and then go off.