Transmission Removal

MANUAL TRANSAXLE

COMPONENTS:

REMOVAL
1. Remove the air duct.
2. Remove the battery.
3. Remove the air cleaner assembly (A).





4. Remove the battery tray (A).





5. Disconnect the ground circuit line (A) from the transaxle.





6. Disconnect the vehicle speed sensor.
7. Disconnect the shift cable assembly (A).





8. Disconnect the back up lamp switch (A).





9. Disconnect the related connectors retranslates.
10. After removing the clip (B) with clamping (A) the concentric slave cylinder tube, disconnect the tube (C).





11. Drain the power steering fluid and disconnect the power steering pressure hose (A) bolt (B).





12. Remove the under shield cover (A).





13. Drain the manual transaxle fluid after removing the transaxle drain plug (A). It can be easier when the oil filler plug (B) is removed.





14. Disconnect the electronic power steering connector.
15. Remove the lower arm ball joint and folk mounting bolts.
16. Remove the lower arm ball joint assembly mounting bolts.
17. Remove the stabilizer bar link mounting bolts.
18. After removing a split pin and nut from the steering bar tie rod, disconnect it.
19. Loosening the power steering return hose (A) clamp (B), disconnect the hose.





20. Disconnect the bracket (B) from the front roll stop per (A).





21. Disconnect the bracket (B) from the rear roll stop per (A).





22. Remove the steering column bolt.
23. Remove the transaxle lower mounting bolts (A).








24. After disconnecting the exhaust pipe (A), disconnect the hanger (B) and the Oxygen sensor connector (C).





25. Supporting the cross member (A) with a jack, remove the stay (C) with the mounting bolts (B).








26. Disconnect the drive shafts (A) from the transaxle (B).








27. Supporting the transaxle with a jack, remove the transaxle support bracket (A) and the upper mounting bolts (B).








28. Lowering the jack slowly, remove the transaxle.