Scan Tool Testing and Procedures

BATTERY TEST PROCEDURE




1. Connect the tester to the battery.
- Red clamp to battery positive (+) terminal.
- Black clamp to battery negative (-) terminal.

CAUTION: Connect clamps securely If "CHECK CONNECTION" message is displayed on the screen, reconnect clamps securely.




2. The tester will ask if the battery is connected "IN A VEHICLE" or "OUT OF A VEHICLE". Make your selection by pressing the arrow buttons; then press ENTER.




3. Choose either CCA or CCP and press the ENTER button.

NOTE:
- CCA: Cold cranking amps, is an SAE specification for cranking batteries at -18 degrees C (0 degree F).
- CCP: Cold cranking amps, is an SAE specification for korean manufacturer's for cranking battedes at -18 degrees C (0 degree F).




4. Set the CCA value displayed on the screen to the CCA value marked on the battery label by pressing up and down buttons and press ENTER.

NOTE: The battery ratings(CCA) displayed on the tester must be identical to the ratings marked on battery label




5. The tester (Micro57O) displays battery test results including voltage and battery ratings
A relevant action must be given according to the test results by referring to the battery test results as shown in the table below.

NOTE: The battery ratings (CCA) displayed on the tester must be identical to the ratings marked on battery label.

6. To conduct starter test, continuously, press ENTER.

Battery Test Results:

BATTERY TEST RESULTS

WARNING: Whenever filing a claim for battery, the print out of the battery test results must be attached.