P0708

DTC P0708 TRANSAXLE RANGE SWITCH - HIGH INPUT





COMPONENT LOCATION

GENERAL DESCRIPTION
Refer to DTC P0707. P0707

DTC DESCRIPTION
Refer to DTC P0707. P0707





DTC DETECTING CONDITION

SCHEMATIC DIAGRAM
Refer to DTC P0707. P0707

MONITOR SCANTOOL DATA
1. Connect scantool to data link connector (DLC).
2. Ignition"ON" & Engine"OFF".
3. Monitor the "TRANSAXLE RANGE SWITCH" parameter on the scantool.





4. Move selector lever from "P" range to "L" range.
5. Does "TRANSAXLE RANGE SWITCH" follow the reference data?
YES >>
^ Fault is intermittent caused by poor contact in the sensor's and/or TCM (PCM)'s connector or was repaired and TCM (PCM) memory was not cleared. Thoroughly check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration or damage. Repair or replace as necessary and go to "Verification Vehicle Repair" procedure.
NO >>
^ Go to "TERMINAL & CONNECTOR INSPECTION" procedure.

TERMINAL & CONNECTOR INSPECTION
Refer to DTC P0707. P0707

POWER SUPPLY CIRCUIT INSPECTION
1. Disconnect "TRANSAXLE RANGE SWITCH" connector.
2. Ignition "ON" & Engine "OFF".








3. Measure voltage between each terminal of the sensor harness connector and chassis ground.
4. Is voltage within specifications?
YES >>
^ Go to "Signal circuit inspection" procedure.
NO >>
^ Check for Short in harness. Repair as necessary and Go to "Verification Vehicle Repair" procedure.

SIGNAL CIRCUIT INSPECTION
1. Ignition "OFF".
2. Disconnect "TRANSAXLE RANGE SWITCH" and "TCM (PCM)" connector.





3. Measure resistance between each terminals of the sensor harness to check for Short.
Specification: Infinite
4. Is resistance within specifications?
YES >>
^ Go to "Component inspection" procedure.
NO >>
^ Check for Open in harness. Repair as necessary and Go to "Verification Vehicle Repair" procedure.

COMPONENT INSPECTION
Refer to DTC P0707. P0707

VERIFICATION OF VEHICLE REPAIR
Refer to DTC P0560. P0560