Seat Occupant Sensor: Service and Repair

OCCUPANT CLASSIFICATION SENSOR (OCS)

REMOVAL
1. Disconnect the battery negative cable, and wait for at least three minutes before beginning work.
2. Remove the front seat assembly.
3. Remove the seat cushion as an assembly.

INSTALLATION
1. Install the OCS equipped seat cushion.
2. Install the front seat assembly.
3. Reconnect the battery negative cable.
4. After installing OCS, confirm proper system operation : Turn the ignition switch ON, the SRS indicator should be turn on for about six seconds and then off. Telltale lamp will turn on for 4 seconds and be turned off for 4 seconds. After the 8 seconds, it shall remain off if the OCS does not require suppression and the passenger airbag is enabled.

NOTE: Be sure to perform OCS (PODS) rezero with scantool in empty seat condition after replacing OCS equipped seat cushion.