Component Inspection

Component Inspection

Check Intake actuator
1. Ignition "OFF"
2. Disconnect Intake actuator and A/C control unit main harness connector.
3. Connect (+) terminal of battery to FRE (+) of intake actuator and (-) terminal to REC (-). (Component side)
4. Verify that the actuator operates to the REC position
5. Verify that the temperature actuator operates to the FRE position with reverse connecting. (REC (-) and FRE (+)) (Component side)

Specification : Refer the specifications in fig. 1



fig. 1)





fig. 1) ** Function of the actuator motor according to terminal connection type. (observe safety regulations)
6. Is "Door position" display near the specified value ?





Check potentiometer
1. Ignition "OFF"
2. Disconnect Intake actuator and A/C control unit main harness connector.
3. Ignition "ON" (ENGINE "OFF").
4. Measure voltage between Signal (F/B) terminal of Intake actuator harness connector and chassis ground. (Component side)

Specification : Refer the specifications in fig. 2)



fig. 2)





fig. 2) ** Specifications : Voltage value of intake potentiometer as a function of intake door position.
5. Is "voltage" display near the specified value ?