Instrument Cluster

Inspection

Oil Pressure Switch
1. Check that there is continuity between the oil pressure switch terminal and ground with the engine off.
2. Check that there is no continuity between the terminal and ground with the engine running.
3. If operation is not as specified, replace the switch.





Oil Pressure Warning Lamp
1. Disconnect the connector from the warning switch and ground the terminal on the wire harness side connector.
2. Turn the ignition switch ON. Check that the warning lamp lights up. If the warning lamp doesn't light, test the bulb or inspect the wire harness.





Brake Fluid Level Warning Switch
1. Remove the connector (A) from the switch located at the brake fluid reservoir.
2. Verify that continuity exists between switch terminals 1 and 2 while pressing the switch (float) down with a rod.





Brake Fluid Level Warning Lamp
1. Ignition "ON".
2. Release the parking brake.
3. Remove the connector from the brake fluid level warning switch.
4. Ground the connector at the harness side.
5. Verify that the warning lamp lights.

Parking Brake Switch
The parking brake switch is a pull type. It is located at the side of the parking brake lever.
1. Check that there is continuity between the terminal and switch body with the switch (A) ON.
2. Check that there is no continuity between the terminal and switch body with the switch OFF.
If continuity is not as specified, replace the switch or inspect its ground connection.





Door Switch
Remove the door switch and check for continuity between the terminals.









Seat Belt Switch
1. Remove the connector from the switch.
2. Check for continuity between terminals.










Seat Belt Warning Lamp
With the ignition switch turned ON, verify that the lamp glows.






Trip Switch
1. Disconnect the negative (-) battery terminal.
2. Remove the cluster facia panel (A).




3. Remove the trip switch (A) from the cluster facia panel (B).




4. Check for continuity between the terminals in each switch position according to the table.






Removal

1. Disconnect the negative (-) battery terminal.
2. Remove the cluster fascia panel (A).





3. Disconnect the trip computer switch connector (A) from the cluster fascia panel.




4. Remove the cluster fascia (A) from the housing after removing 4 screws.




5. Disconnect the cluster fascia connecters(A) and then remove the cluster.






Installation

1. Connect the cluster connector.
2. Install the cluster assembly.
3. Connect the trip switch connector.
4. Install the center facia panel.