Repair Procedures

Removal

1. Disconnect the battery negative cable and wait for at of least 3 minutes before beginning work.
2. Remove the following parts.
A. Side trim, Roof trim
3. Disconnect the Curtain Airbag harness connector.




4. After loosening the mounting bolts, remove the curtain airbag.

Installation

CAUTION:
- Be sure to install the harness wires not to be pinched or interfered with other parts.

1. Remove ignition key from the vehicle.
2. Disconnect the negative (-) cable from battery and wait for at least three minutes.
3. Install a Curtain Airbag(CAB) on the mounting bracket.
4. Tighten the CAB mounting bolts.

Tightening Torque
: 10.8 - 12.7 Nm(1.1 - 1.3 kgf.m, 7.9 - 9.4 lb.ft)


CAUTION:
- Never twist the airbag module when installing it. If the module is twisted, airbag module may operate abnormally.

5. Connect the CAB connector.
6. Install the following parts.
A. Side trim, Roof trim
7. Reconnect the battery negative cable.
8. After installing the Curtain Airbag(CAB), confirm proper system operation:
A. Turn the ignition switch ON; the SRS indicator light should be turned on for about six seconds and then go off.