Rear Wiper Motor

Replacement

1. Detach the wiper cap (A), then remove the rear wiper arm (C) after removing a nut (B).

Tightening torque Nut(B) :
10 - 14 Nm (1.0 - 1.4 kgf.m, 7 - 10 lbf.ft)





2. Remove the rear wiper cap & pad (C) after removing a nut (B) and cover (A).

Tightening torque Nut (A) :
10 - 14 Nm (1.0 - 1.4 kgf.m, 7 - 10 lbf.ft)





3. Open the tailgate then remove the tailgate trim.
4. Disconnect the rear wiper motor connector then remove the rear wiper motor (A) after removing 2 bolts.

Tightening torque Nut :
10 - 14 Nm (1.0 - 1.4 kgf.m, 7 - 10 lbf.ft)





5. Installation is the reverse of removal.

NOTE:
Before installation, be sure that the rear wiper motor is in the park position.
Turn the wiper switch ON and OFF to allow the rear wiper motor to cycle and stop in the park position.