General Information

Component Location





General Description

Temperature control actuator located at heater unit regulates the temperature by the procedure as follows. Signal from control unit adjusts position of temp door by operating temp motor. then temperature will be regulated by the hot/cold air ratio decided by position of temp door

DTC Description

The ECM sets DTC B2406 if the air mix actuator doesn't move to intended position within 40 sec (The ECM attempts to move the temp door for a 2 second duration at a frequency of 3 times every 20 seconds before storing a DTC.)

DTC Detecting Condition





Specification

** Voltage value of Air Mix potentiometer as a function of setting temperature






Schematic Diagram