Scantool Diagnostics

Monitor Scantool Data

1. Start engine and turn headlight and rear defroster on.
2. Connect 'TPMS exciter' or scantool to Data Link Connector (DLC).
3. Select "TPMS DIAGNOSIS" mode.
4. Select the "FULL" mode of "CURRENT DATA" function.
5. Maintaining ENG. RPM at 2,500 RPM (idle) over 2 minutes.
6. Monitor the parameter of BATT. VOLT on the 'TPMS exciter' or scantool.

Specification : 'BATT. VOLT' is more than 10V









Fig 1) Sensor current data (normal)
Fig 2) BATT. VOLT low
Fig 3) Connect the DLC for 'TPMS exciter'
7. Is parameter within specifications ?