Component Inspection

Component Inspection

[Check TPM SENSOR 4]
1. Turn ON 'TPMS exciter'.
2. Select "TIRE SNSR CONFIG (EXCITER)" mode.
3. Execute "SET SENSOR STATUS" of each wheel.
4. Monitor the parameter of each sensor temperature on the 'TPMS exciter'.

Specification : Less than 230 °F (110 °C)





Fig 1) Sensor status (normal)
Fig 2) Executing "SET SENSOR STATUS"
5. Is any sensor data outside specification ?





[Check wheel/tire]
1. Cool the heat of the SENSOR 4 wheel/tire.
2. IG OFF & IG ON.
3. Monitor the parameter of SENSOR 2 temperature on the 'TPMS exciter' or scantool after 4 minutes.

Specification : Less than 230 °F (110 °C)


4. Is parameter within specifications ?