Component Inspection

Component Inspection

[Check status of all TPM sensor]
1. Turn ON 'TPMS exciter'.
2. Select "TIRE SNSR CONFIG (EXCITER)" mode.
3. Execute "SET SENSOR STATUS" of each wheel.




Fig 1) Sensor status (normal)
Fig 2) Executing "SET SENSOR STATUS"
4. Are status of all sensors "normal" ?





[Check TPMS receiver]




Fig 1) Connect the DLC for 'TPMS exciter'
1. Connect 'TPMS exciter' or scantool to Data Link Connector (DLC).
2. Clear DTC.
3. IG OFF & IG ON. Wait 4 minutes.
4. Execute "Diagnostic Trouble Codes (DTCs)" mode.
5. Is 'C1660' present ?