Alarm Module: Service and Repair

Replacement

[USA]
1. Disconnect the negative (-) battery terminal.
2. Remove the driver crash pad lower panel(A) after removing side cover.




3. Disconnect connectors of lower panel.
4. Disconnect the 5P connector of the Immobilizer unit and then remove the Immobilizer unit (A) after loosening a nut.




5. Installation is the reverse of removal procedure.

[CANADA]
1. Disconnect the negative (-) battery terminal.
2. Remove the crash pad lower panel (A). Avoid damaging retaining clip.




3. Remove ICM relay connector and 2 nuts.




4. Remove the body control module (A) and tilt & telescope unit after loosening 2 nuts and disconnecting connector.




5. Disconnect the immobilizer unit connector and then remove the immobilizer unit(A) after loosening a shear bolt or removing the unit from the mounting bracket (B) using a flat-up screwdriver.




6. Installation is the reverse of removal procedure.