Component Inspection

Engine

Engine Control - P0222 Throttle/Pedal Position Sensor/Switch 'B' Circuit Low Input - Component Inspection

Component Inspection

1. Check TPS
(1) IG "OFF" and disconnect TPS connector.
(2) Measure resistance between terminals 1 and 5 of TPS connector. (Component side)

Specification : 2.7 - 4.1 kOhms




(3) Is the measured resistance within specification?






NOTE:
There is a memory reset function on scantool that can erase optional parts automatically detected and memorized by PCM. After testing PCM on the vehicle, use this function to reuse the PCM on the others

CAUTION:
Procedure of ETS Initialization
1. Erase the trouble codes on PCM
2. Turn the ignition key off and keep this condition until the main relay is turned off. (It will takes 10 sec.)
3. Turn ignition key on more than 1 second to record the throttle motor position on the EEPROM