Component Inspection

Engine

Engine Control - P0341 Camshaft Position Sensor A Circuit Range/Performance (Bank 1 or Single Sensor) - Component Inspection

Component Inspection

1. Check CMPS
(1) IG "OFF" and connect scantool.
(2) ENG "ON" and Measure signal waveform at terminal 3 of CMPS.

Reference signal waveform :




(3) Is the measured signal waveform normal?






NOTE:
There is a memory reset function on scantool that can erase optional parts automatically detected and memorized by PCM. After testing PCM on the vehicle, use this function to reuse the PCM on the others