Repair Procedures

Replacement

Power Window Motor Replacement
1. Remove the rear door trim.
2. After disconnecting the connector (A), remove the power window motor (B).




3. Installation is the reverse of removal.

NOTE:
- Roll the glass up down to see if it move freely without binding.

Module Assembly Replacement
1. Remove the rear door trim.
2. Remove the glass.
3. Remove the inside handle.
4. Remove the outside handle.
5. After loosen the door module mounting bolts, remove the door module (A).




6. Disconnect the connector (C).
7. Detach the clips, then remove the wiring harness (A).
8. Remove the module (B).




9. Installation is the reverse of removal.

NOTE:
- Make sure the connector is plugged in properly and each cable is connected securely.
- Make sure the door lock and open properly.

Power Window Switch Replacement
1. Remove the rear door trim.
2. Loosen the mounting screws (A).




3. Remove the power window switch (A).




4. Installation is the reverse the removal.