Component Inspection

Brake

Electronic Stability Control - C1261 Steering Angle Sensor Not Calibrated - Component Inspection

Component Inspection

1. Line up wheels like Figure 1.
(1) Perform the wheel alignment.
(2) Set the steering wheel so that the wheels point straight ahead.
(3) Go ahead and Go back the vehicle 2 - 3 times without holding steering wheel.
2. Connect scantool to Data Link Connector (DLC).
3. Go in Elec. Power Steering system.
4. Perform ASP calibration. (Figure 2).
5. Check the condition of "SAS 0 SET" by operating the vehicle (turn right and left at least 1 time)








6. Is "SAS 0 SET" completed normally?