Component Inspection

Lane Departure Warning System
C1364 Not found Reference Point - Component Inspection

Component Inspection

Check the use of LDWS Calibration Board
1. Check if LDWS Reference Point Calibration was done under setting up LDWS calibration board as below.




2. Did LDWS board for Calibration be used as above?





Check the status of LDWS Calibration Board
1. Check LDWS lens' vision field.
- This fault may be caused by being contaminated by a foreign material in the lens' vision field.
- If the lens is dirty, clean it.
2. Using a scantool, Clear DTC.
3. Let LDWS system turn OFF, and then turn it ON, again.
4. Install the LDWS board for calibration as below, repeat to perform LDWS Reference Point Calibration.




At setting up, the end of emblem and the end of special tool have to come in contact with each other.
5. Does this DTC come out again?