W/Harness Inspection

Engine Control
P0458 Evaporative Emission System Purge Control Valve Circuit Low - W/Harness Inspection

Terminal and Connector Inspection

1. Many malfunctions in the electrical system are caused by poor harness and terminals.
Faults can also be caused by interference from other electrical systems, and mechanical or chemical damage.
2. Thoroughly check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration, or damage.
3. Has a problem been found?






Power Circuit Inspection

Check Open or Short in power circuit
1. IG "OFF" and disconnect PCSV connector.
2. IG "ON".
3. Measure voltage between power terminal of PCSV harness connector and chassis ground.

Specification : B+




4. Is the measured voltage within specification?






Control Circuit Inspection

Check Open or Short in control circuit
1. IG "OFF" and disconnect PCSV connector.
2. IG "ON".
3. Measure voltage between control terminal of PCSV harness connector and chassis ground.

Specification : Approx. 3.5 V




4. Is the measured voltage within specification?