Front Seat
Replacement
Seat Assembly Replacement
1. Disconnect the battery negative cable, and wait for at least three minutes before beginning work.
2. Using a flat-trip screwdriver, remove the seat belt anchor pretensioner (A).
3. After loosening the seat assembly mounting bolts, then remove the seat assembly (B).
Tightening torque :
Nut : 34.3 - 49.0 N.m (3.5 - 5.0 kgf.m, 25.3 - 36.2 lb-ft)
Bolt : 34.3 - 53.9 N.m (3.5 - 5.5 kgf.m, 25.3 - 39.8 lb-ft)
4. Disconnect the power seat connectors (A).
5. Installation is the reverse of removal.
NOTE:
- Be sure to perform PODS re-zero with the GDS after replacing parts(passenger's)
Seat Back Cover Replacement
1. Remove the front seat assembly.
2. Detach the clips (B), then remove the seat back cover (A).
3. Disconnect the connector (A).
4. Remove the headrest (A) with pushing the headrest switch to the top position.
5. Disconnect the protector (A) from the seat back frame.
6. Loosen the mounting screws, then remove the mounting bracket (A).
7. Pull out the headrest guides (A), while pinching the end of the guides, and remove them.
8. Remove the seat back from the frame.
9. After removing the hog-ring clips on the front of seat cushion and remove the seat back cover (A).
CAUTION:
- When removing the hog-ring clip, remove the hog-ring clip with pressing the wire not to separate the wire from the sponge.
10. Installation is the reverse of removal.
NOTE:
- To prevent wrinkles make sure the material is stretched evenly over the cover (B) before securing the hog-ring clips (A).
- Replace the hog-ring clips with new ones using special tool (C) (09880-4F000).
NOTE:
- Be sure to perform PODS re-zero with the GDS after replacing parts(passenger's)
Seat Cushion Cover Replacement
1. Remove front seat assembly.
2. Remove the recliner cover.
3. After disconnect the protector (A), remove the seat cushion (B).
4. Loosen the mounting screws, then remove the mounting bracket (A).
5. After removing the hog-ring clip on the front of seat cushion and remove the seat cushion cover (A).
CAUTION:
- When removing the hog-ring clip, remove the hog-ring clip with pressing the wire not to separate the wire from the sponge.
6. Installation is the reverse of removal.
NOTE:
- To prevent wrinkles make sure the material is stretched evenly over the cover (B) before securing the hog-ring clips (A).
- Replace the hog-ring clips with new ones using special tool (C) (09880-4F000).
NOTE:
- Be sure to perform PODS re-zero with the GDS after replacing parts(passenger's)
Seat Frame Replacement
1. Remove the front seat assembly.
2. Remove the seat back.
3. Remove the seat cushion.
4. Disconnect the connector (C).
5. After loosening the mounting bolts, then disconnect the seat back frame (A) and seat cushion frame (B).
Tightening torque :
53.9 - 63.7 N.m (5.5 - 6.5 kgf.m, 39.8 - 47.0 lb-ft)
6. Installation is the reverse of removal.
NOTE:
- Remove the side air bag for replacing side air bag installation seat.
- Before service, be fully aware of precautions and service procedure relevant to air bag.
- Be sure to perform PODS re-zero with the GDS after replacing parts(passenger's)