Repair Procedures

Removal

1. Disconnect the negative (-) battery terminal.
2. Remove the rear seat assembly.

3. Remove the rear seat frame.
4. Remove the partition trim and partition panel.

5. Remove the rear massage pump (A) on the right side of seat after removing the nuts and connector.






Installation

1. Install the rear massage pump.

CAUTION:

A. Confirm that the air hoses and wirings are installed in properly.
2. Install the partition trim and partition panel.
3. Install the rear seat frame.

CAUTION:

A. Take care not to damage the air hoses and wirings when installing rear seat frame.
B. Pressing and bending of the air hoses and wirings should be cause of abnormal operation.
4. Install the rear seat assembly.
5. Check the rear massage seat system.