Knock Sensor: Service and Repair

Removal

1. Turn the ignition switch OFF and disconnect the battery negative (-) cable.
2. Remove the intake manifold.
3. Remove the knock sensor from the cylinder block.










Installation

CAUTION:
- Install the component with the specified torques.
- Note that internal damage may occur when the component is dropped. In this case, use it after inspecting.

1. Installation is reverse of removal.

Knock sensor installation bolt:
14.7 - 24.5 N.m (1.5 - 2.5 kgf.m, 10.9 - 18.1 lb-ft)