Crankshaft Position Sensor: Service and Repair

Inspection

1. Check the signal waveform of the CMPS and CKPS using a scantool.

Specification:Refer to "Wave Form" Testing and Inspection

Removal

1. Turn the ignition switch OFF and disconnect the battery negative (-) cable.
2. Disconnect the crankshaft position sensor connector (A).




3. Remove the installation bolt (B), and then vertically remove the sensor from the transaxle housing.






Installation

CAUTION:
- Install the component with the specified torques.
- Note that internal damage may occur when the component is dropped. In this case, use it after inspecting.

CAUTION:
- Apply the engine oil to the O-ring.

CAUTION:
- Insert the sensor in the installation hole and be careful not to damage when installation.

1. Installation is reverse of removal.

Crankshaft position sensor installation bolt:
9.8 - 11.8 N.m (1.0 - 1.2 kgf.m, 7.2 - 8.7 lb-ft)