W/Harness Inspection

A6MF2H

P0735 Gear 5 Incorrect Ratio - W/Harness Inspection

Signal Circuit Inspection

1. Connect scantool to Data Link Connector (DLC).
2. Engine "ON".
3. Select "Current Data"mode and monitor "Engine speed, Input speed sensor (PG-A), Output speed sensor (PG-B) and Gear position" parameter used select option.
4. Engine speed up to about 2000 rpm and check Input speed (PG-A) & Output speed (PG-B) are within specific at 5th speed of gear.

Specification :
Output speed>(input speed+200 rpm)/5th. gear ratio
Output speed<(input speed-200 rpm)/56th. gear ratio




5. Are measured Input speed (PG-A) & Output speed (PG-B) within specific?