Repair Procedures

Replacement

Seat Assembly Replacement
1. Remove the rear seat cushion (A).




2. Disconnect the seat heater connectors (A).




3. After loosening the mounting bolts, then remove the rear seat back (A).

Tightening torque :
44.1 - 58.8 N.m (4.5 - 6.0 kgf.m, 32.5 - 43.4 lb-ft)




4. Installation is the reverse of removal.

NOTE:
Seat mounting bolt and nut installation procedure.
- Tighten temporarily in the order of nut and bolt on the front of recliner hinge installation part.
- After completely tightening completely the bolt on the back of the recliner hinge installation part, tighten the bolt on the front of it completely.
- Setting down the seat cushion, tighten the mounting bolt of the cushion frame hinge.
- Check if reclining the seat and folding seat back operate smoothly.

Armrest Replacement
1. After loosening the mounting nuts, then remove the armrest(A).




2. Installation is the reverse of removal.