Component Inspection

Electronic Stability Control

C1513 Brake Switch Error - Component Inspection

Component Inspection

Brake light switch Check
1. IG "OFF".
2. Disconnect the brake light switch connector.
3. Measure resistance between power terminal and signal terminal of the brake light switch A, B connector.

Specification : Resistance between terminals of the brake light switch A - Infinity Ohms (when the plunger is pushed down), 0 Ohms (when the plunger isn't pushed down).
Resistance between the terminals of the brake light switch B - Infinity Ohms (when the plunger is not pushed down), 0 Ohms (when the plunger is pushed down).




4. Is the measured waveform within specifications?