Repair Procedures

Replacement

Sunvisor Replacement

NOTE:
- When prying with a flat-tip screwdriver, wrap it with protective tape to prevent damage.
- Put on gloves to protect your hands.

1. Loosen the mounting screws, then remove the sunvisor (A) and retainer (B).




2. Installation is the reverse of removal.

Assist Handle Replacement

NOTE:
- When prying with a flat-tip screwdriver, wrap it with protective tape to prevent damage.
- Put on gloves to protect your hands.

1. Remove the covers (A) and screws, then remove the assist handle (B).




2. Installation is the reverse of removal.

Overhead Console Lamp Replacement

NOTE:
- When prying with a flat-tip screwdriver, wrap it with protective tape to prevent damage.
- Put on gloves to protect your hands.

1. After loosening the mounting screws, remove the overhead console (A).




2. Disconnect the connectors (B).




3. Installation is the reverse of removal.

Room Lamp Replacement

NOTE:
- When prying with a flat-tip screwdriver, wrap it with protective tape to prevent damage.
- Put on gloves to protect your hands.

1. Remove the covers (A).
2. After loosening the mounting screws, then remove the room lamp (B).




3. Disconnect the connector (A).




4. Installation is the reverse of removal.

Hands Free Mic and Lamp Replacement
1. Remove the hands free mic (A) and lamp (B).








2. Installation is the reverse of removal.

Roof Trim Replacement

NOTE:
- Put on gloves to protect your hands.
- When prying with a flat-tip screwdriver, wrap it with protective tape to prevent damage.
- Take care not to bend or scratch the trim and panels.

1. Remove the following items:
A. Sunvisor
B. Overhead console
C. Room lamp
D. Assist handle
E. Front pillar trim

F. Canter lower pillar trim

G. Canter upper pillar trim

H. Rear pillar trim

2. Disconnect the connector (A).
[Driver's]




[Passenger's]




3. Disconnect the clips.
4. Remove the roof trim (A).




5. Installation is the reverse of removal.

NOTE:
- Replace any damage clips.