Repair Procedures

Inspection

CD changer operation instructions

NOTE:
- CD changer operation instructions may be somewhat different according to the CD changer model.
The following method is just one example.




1. Press and release LOAD button.

CAUTION:
- Be sure to press LOAD to open the CD slot. If feeding a CD into the slot by force, it may cause damage to the CD changer.

2. After "WAIT" is displayed on the LCD, the CD slot will open with "LOAD" displayed on the LCD.
3. Insert a CD. The player will pull the disc in and begin to play automatically.

CAUTION:
- CD can be inserted only while "LOAD" is blinking on the LCD and the CD slot indicator is flashing.
- CD must be inserted with the label facing upward.
- This CD player is suitable only for 12cm discs. DO NOT use irregular shaped CDs.

4. To insert multiple discs, press and hold LOAD button for more than 0.8 seconds. A beep sound will be heard and it will let you load CDs into all of the slots in which no CD has been loaded.

CAUTION:
- This CD player takes up to 6 discs. DO NOT try to load more than six.

CD changer improper operation cases
If inserting a CD into the CD slot by force, the CD door behind the slot may be broken or separated from the head. It will cause the CD player not to work. Be sure to press LOAD button before inserting a CD.
CDs jammed in the CD player deck
DO NOT insert foreign substances like coins or tickets into the CD player. It may cause damage to the CD player.

Removal

1. Disconnect the negative (-) battery terminal.
2. Remove the upper tray(A).
.




3. Remove the crash pad center facia panel (A).

NOTE:
Take care not to scratch the crash pad and related parts.




4. Disconnect the connectors from the crash pad center facia panel.




5. Remove the mounting bolts then remove the audio unit(A).




6. Disconnect the audio connectors and cable(A).





External Amplifier
1. Remove the right side trunk trim and disconnecting the connector
.
2. Remove the external amplifier(A) after loosening the 3 nuts.






Installation

1. Connect the audio unit connectors and cable.
2. Install the audio unit.
3. Install the crash pad center facia panel.
4. Install the upper tray.
5. Check the audio system.

NOTE:
- Make sure the audio head unit connectors are plugged in properly, and the antenna cable is connected properly.

External Amplifier
1. Install the external amplifier and connect the external amplifier connector.
2. Install the right side trunk trim.