Component Inspection

Lane Depature Warning System
C1365 Invalid Reference Point - Inspection/Repair:_:Component Inspection

Component Inspection

Check the status of LDWS Calibration Board
1. Check LDWS lens' vision field.
- This fault may be caused by being contaminated by a foreign material in the lens' vision field.
- If the lens is dirty, clean it.
2. Using a scantool, Clear DTC.
3. Let LDWS system turn OFF, and then turn it ON, again.
4. Install the LDWS board for calibration as below, repeat to perform LDWS Reference Point Calibration.




∗ At setting up, the end of emblem and the end of special tool have to come in contact with each other.
5. During calibration, does this DTC come out again ?