W/Harness Inspection

Pre-safe Seat Belt-Left
C1410 Undervoltage Detected - Inspection/Repair:_:W/Harness Inspection

Terminal & Connector Inspection

1. Many malfunctions in the electrical system are caused by poor harness and terminals.
Faults can also be caused by interference from other electrical systems, and mechanical or chemical damage
2. Thoroughly check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration, or damage.
3. Has a problem been found?






Power Circuit Inspection

1. Engine "ON", headight and heatwire "ON".
2. Measure voltage between the battery terminal (+) and (-) maintaining ENG. RPM 2,500RPM (idle) over 2 minutes.
3. Measure voltage between ON/START input of the PSB LH harness connector and chassis ground.
4. Measure voltage between battery power input of the PSB LH harness connector and chassis ground.

Specification :Approx. Battery V




5. Is the measured voltage within specifications?






PSB-LH Actuation Test

1. IG "ON" & ENG "OFF"
2. After connect GDS, select "Current Date" menu.
3. Buckled driver seat belt and select "actuation test" mode.
4. Execute "actuation test" at PSB LH

Specification :PSB LH Actuation test is success within specific working.




Fig.1) PSB-LH actuation test successful states at Driver seat belt buckled after(KEY ON)
5. Is PSB LH motor working normal ?