Scantool Diagnostics

Electronic Control Suspension
C1620 1st set-up not completed(Height Sensor Not Cailbrated) - Scantool Diagnostics

Monitor GDS Data

1. Make a vehicle's level to normal level.
2. After IG "OFF", connect scantool to Data Link Connector(DLC) and then, IG "ON"
3. Using GDS, Operate "Height sensor's Calibration" program.
4. Using a tape-measure, Enter the actual height into the GDS.
5. Compare the current height of scantool with the actual height.
6. In a case of getting out of specification below , Repeat from procedure No.3 to procedure No.5, again.

Specification- Front-wheel : 393±10mm
- Rear-wheel : 386±10mm




7. Is the height sensor's calibration completed?