Repair Procedures

Replacement

NOTE:
- After remove the rear combination lamp.
- When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts your hands.
- Put on gloves to protect your hands.
- Take care not bend or scratch the cover and other parts.

1. Remove the transverse trim.
2. Remove the luggage side trim.
3. Disconnect the connector (A), then remove the mounting nuts.




4. Remove the rear combination lamp (A).




5. Remove the rear bumper side's screws.




6. Disconnect the rear bumper wiring connector (A).




7. Loose the inside mounting bolts (B).
8. Loose the mounting screws and bolts.
9. Remove the rear bumper (A) and rail.




10. Installation is the reverse of removal.