Parking Brake Shoe: Service and Repair

Parking Brake Shoe

Removal

1. Raise the vehicle, and make sure it is securely supported.
2. Remove the rear tire and wheel.
3. Remove the brake caliper and Rear disc brake.
4. Remove the parking brake cable (B), after removing the bolt (A).




5. Remove the shoe hold down pin (A) and the spring (B) by pushing the retainer spring and turning the pin.




6. Remove the adjuster assembly (B) and the lower return spring (A).




7. Remove the upper return spring (C) and the brake shoes (D).




8. Remove the operating lever assembly (E).

Installation

1. Install the operating lever assembly (E).




2. Install the upper return spring (C) and the brake shoes (D).
3. Install the adjuster assembly (B) and the lower return spring (A).




4. While pressing the spring, install the brake shoe hold down pin (A) and spring (B).




5. Install the parking brake cable (B), then install the bolt (A).

Tightening torque:
6.9 - 10.8 N.m (0.7 - 1.1 kgf.m, 5.1 - 8.0 lb-ft)





NOTE:
How to install the DIH cable (Quick Fit type)
1. Put the inner cable into the knuckle hole in DIH lever operating direction when installing the cable (B).
2. Confirm by pulling the cable that cable is fixed certainly before installing the bolt (A).

6. Install the rear brake disc, then adjust the rear brake shoe clearance.
(1) Remove the plug from the disc.




(2) Rotate the toothed wheel of adjuster by a screw driver until the disc is not moving, and then return it by 5 notches in the opposite direction.
7. Install the brake caliper assembly.
8. Install the tire and wheel.
9. If the parking brake shoe or the brake disc are replaced a newly one, perform the brake shoe bed-in procedure.