Component Inspection

Engine Control
P0022 - Inspection/Repair:_:Component Inspection

Component Inspection

Check OCV resistance
1. IG "OFF" and disconnect OCV connector.
2. Measure resistance between power and signal terminals of OCV. (Component Side)

Specification :6.7 - 7.7 at 20°C (68°F)




3. Is the measured resistance within specification?





Check CAM PHASER with actuation test
1. Connect GDS and IG "ON"
2. Select "Cam Phaser Intake Bank2" on the Actuation Test
3. Select "Intake Oil Control Valve" on the Actuation Test
4. Activates "Cam Phaser Intake Bank2" by pressing "START" button
5. Activates "Intake Oil Control Valve" by pressing "START" button
6. Repeat this procedure 4 or 5 times to ensure CAM PHASER and valve control solenoid reliability








7. Has a problem been found ?