W/Harness Inspection

Front Back Warning System
B1216 Rear Center Right Sensor Fault - Inspection/Repair:_:W/Harness Inspection

Terminal and Connector Inspection

1. Many malfunctions in the electrical system are caused by poor harness(es) and terminals. Faults can also be caused by interference from other electrical systems, and mechanical or chemical damage.
2. Thoroughly check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration, or damage.
3. Has a problem been found?






Power Circuit Inspection

1. IG "ON" & ENG "OFF"
2. Measure the power voltage of "Rear Center Right Sensor". (FBWS side)

Specification :Approx. 8 V




3. Is the signal output normal?





Ground Inspection
1. IG "ON" & ENG "OFF"
2. Measure voltage between power and ground terminal of rear center right sensor.

Specification :Approx. 8 V




3. Is the signal output normal?





TX, RX line of rear center right sensor check
1. KEY "OFF"
2. Disconnect FBWS unit and rear center right sensor connector.
3. Measure resistance of TX, RX line between FBWS unit and rear center right sensor harness connector.

Specification :Approx. 1 Ohms




4. Is measured value normal?